Pro-face PFXGM4201TAD Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 74
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
GP-4201TM/4301TM/4000M Hardware Manual
16
Certifications and Standards
Introduction
Pro-face submitted this product for independent testing and qualification by third-
party listing agencies. These agencies have certified this product as meeting the
following standards.
Agency Certifications for GP Unit
GP unit is certified by the Underwriters Laboratory according to:
UL 508 and CSA C22.2 n142 for Industrial Control Equipment
ANSI/ISA 12.12.01 and CSA C22.2 n213 for Electrical Equipment for Use in Class
I, Division 2 Groups A, B, C and D Hazardous (classified) Locations
NOTE:
For use in Pollution Degree 2 environments.
For use on a flat surface of Type 4X Enclosure.
Hazardous Substances
GP unit is designed for compliance with:
WEEE, Directive 2002/96/EC
RoHS, Directive 2002/95/EC
RoHS China, Standard SJ/T 11363-2006
UL Conditions of Acceptability and Handling Cautions for GP Unit
The GP unit is suitable for use in hazardous locations in accordance with Class I,
Division 2 Groups A, B, C and D standards. All relevant local, state, and regional
codes must be followed.
WARNING
RISK OF EXPLOSION IN HAZARDOUS LOCATIONS
Verify that the power, input and output (I/O) wiring are in accordance with Class
I, Division 2 wiring methods.
Substitution of any components may impair suitability for Class I, Division 2.
Do not disconnect equipment unless power has been switched off or the area
is known to be Non-Hazardous.
Securely lock externally connected units and each interface before turning on
the power supply.
Do not disconnect while circuit is live unless area is known to be Non-
Hazardous.
USB mini-B connector is for temporary connection only. Do not use, connect, or
disconnect unless area is known to be non-hazardous.Connection or
disconnection in an explosive atmosphere could result in an explosion.
Potential electrostatic charging hazard: wipe the front panel of the terminal with
a damp cloth before turning ON.
Do not substitute a rear module labeled GP-4201TM/4301TM by a rear module
labeled PFXGM4B01D when installed in Hazardous Locations.
Failure to follow these instructions can result in death, serious injury, or
equipment damage.
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 73 74

Comments to this Manuals

No comments