Pro-face PFXGP4501TAA Manual download pdf (Page 158)

Installation and Wiring

158

USB Cable Clamp for USB (Type A)

Introduction

When using a USB device, attaching a USB cable clamp to the USB interface to

prevent the USB cable from being disconnected.

Attaching the USB Cable Clamp

NOTE: Watch your fingers. The edge of the clip is sharp.

DANGER

POTENTIAL FOR EXPLOSION

z Verify that the power, input and output (I/O) wiring are in accordance with Class

I, Division 2 wiring methods.

z Substitution of any component may impair suitability for Class I, Division 2.

z Confirm that the USB cable has been attached with the USB cable clamp before

using the USB interface.

z Remove power before attaching or detaching any connectors to or from the unit.

Failure to follow these instructions will result in death or serious injury.

Step Action

Mount the clip to the USB mark connector shell so that it overlaps. The

clip matches the 27 to 43.5 mm [1.06 to 1.71 in.] length of the USB connector.

2 Align the clip and the USB cable connector shell. Adjust the position of the

holes where the clip is attached. To ensure stability, select the clip-hole

position that is closest to the base of the connector shell.

27 to 43.5 mm

[1.06 to 1.71 in.]

Pass the tie through here.

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 239 240

No comments

Pro-face PFXGP4501TAA Manual Page 158