Pro-face GP-2500 User Manual download pdf (Page 152)

GP-2400/2500/2600 Series User Manual 8-7

Chapter 8 - Maintenance

8) Connect the backlight's one (1) power

connector. Next, close the circuit board

and secure the rear case in place using

the attachement screws removed in steps

1), 2) and 3).

5) Disconnect the backlight's one (1) power

connectors.

6)Loosen the backlight unit attachment

screw. Next, slide the backlight in the di-

rection shown and lift it forward and re-

move it from the GP.

7) Insert the new backlight in the GP. Insert

the unit by sliding it in the direction

shown in step 6), then, tighten the unit’s

attachment screw.

• Be sure not to pinch or cut any of

the GP unit's internal wiring when

closing the case.

• If any of the attachment screws be-

comes misplaced, check to be

sure that they have not fallen in-

side the GP. If a screw has fallen

inside the GP, do not connect the

unit’s power cord until it has been

removed.

Connector

Attachment Screw

1 2 ... 147 148 149 150 151 152 153 154 155 156 157

No comments

Pro-face GP-2500 User Manual Page 152