Pro-face LT Series Installation Guide download pdf (Page 29)

LT-4201TM/4301TM Installation Guide

English

Avoid temperature changes on the thermocouple’s connection terminal. Temperature

measurements may not be accurate due to temperature changes in the cold junction (LT

connection terminal for the thermocouple compensation cable).

The figure shows the labels on each terminal block:

NOTE: Appearance of the connectors are the same but are different. Check the label and

pin position of each connector before connecting.

Wiring to the DIO Terminal Block

Screwdriver Required to Wire Terminal Blocks

Recommended type: 1891348-1 (Tyco electronics AMP)

If another manufacturer, be sure that the part has the following dimensions:

 point depth: 1.5 mm (0.06 in)

 point height: 2.4 mm (0.09 in)

Point shape must be DIN5264A and meet standard DN EN60900.

CAUTION

EQUIPMENT DAMAGE

Be sure to remove the terminal blocks from the equipment prior to wiring.

Failure to follow these instructions can result in injury or equipment damage.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 46 47

No comments

Pro-face LT Series Installation Guide Page 29